-
5
-
FIGURE 5
ASSEMBLY FOR HANDLE BAR
Step
1
. Take off the bolts(H4), spring washers(H3) & washers(H
2
) from the axle tube(H
1
) before
assembly.
Step
2
. Push axle tube(H
1
) into the middle of the tube welded at right angles to supporting tube(F).
Step 3. Push on handle bar(B
2
) & (B
1
) from each side.
** ATTENTION: The handles must be positioned after assembly so that the upper ends are bent
outwards.
Step 4. There are 8 setting to change the level of resistance.
1
is the lightest tension setting.
8 is the heaviest tension setting.
