User’s manual
The Ability system
9
If a partition has memory of an alarm or tamper condition, the character
that represents the partition concerned will blink.
The right side of the second line shows several icons which provide visual
information regarding the system. Their meanings are described in the
following table.
Nota Bene
If duly programmed by the installer, the
icon will not be shown on the
display when Teleservice is enabled.
The third line shows zone alarms and zone tamper status.
The fourth line shows the faults status.
2-3-2
Display - standby status
A)
If the control panel is in Maintenance status, the first line on the
screen will show the string indicated in the figure. The characters
“K03” indicate the address of the keypad itself (in the example, the
keypad is at address 3).
B)
If a keypad partitions has Alarm or Tamper memory, the third line of
the screen will flash the descriptions of the zones concerned every 3
seconds. In the event of partition alarm or tamper memory, the red
LED on the keypad and the characters corresponding to the parti-
tions concerned will blink.
C)
If the "View open zones of disarmed partitions" option is enabled,
the third line on the screen will flash (approximately every 3 sec-
onds) the descriptions of any zones which are not-in-standby status
when the keypad partitions disarm. Any auto-bypassable zones will
be shown in white on black background.
Nota Bene
Case C is discernible from case B in the fact that in case B, the red LED on the
keypad blinks.
Case C is shown only if case B is not present.
Table 2:
The icons (shown on the second line of the display)
Icon
Name
Not present
On solid
Blinking or interchanging icons
Telephone line
Telephone line busy
(Icon blinking)
Telephone line down
Peripheral tamper
All peripherals are properly
placed and all enclosures
are closed.
At least one peripheral
(keypad, reader, expansion) is
in tamper status (enclosure
open or device dislodged).
(Interchanging icon)
All peripherals are properly placed and
all enclosure covers are closed,
however, tamper has been detected
and cleared (Tamper memory).
Peripheral Loss
All the peripherals in the
system configuration are
responding properly
(Present).
At least one peripheral
(keypad, reader, expansion) is
not responding properly.
(Interchanging icon)
All the peripherals in the system
configuration are responding properly,
however, loss of a peripheral has been
detected and cleared (Peripheral Loss
memory).
Teleservice
Teleservice disabled
Teleservice enabled
Key
(Icon blinking)
False key
Control panel Tamper
The Control panel is
properly placed and the
enclosure is closed.
The Control panel is in tamper
status (enclosure open or
device dislodged).
(Interchanging icon)
The Control panel is properly placed
and the enclosure is closed, however,
panel tamper has been detected and
cleared (Panel tamper memory).
M a i n t e n K 0 3
D T P I D
N o a l a r m s
N o f a u l t s
1 8 : 2 3 2 0 / 0 8 / 2 0 1 1
D T P I D
P a n e l T 0 3
N o f a u l t s
