AbiSee Eye-Pal SOLO LV, User Manual

5 

Quick Start for Eye-Pal SOLO LV 

Step 1- Turn on the Eye-Pal SOLO LV by holding in the green round button 
located on the right side of the front panel.  

Step 2- Turn the black volume knob, in the middle of the front panel, 
clockwise. A tune will play while the software loads. 

Once Eye-Pal SOLO LV is done loading, you will hear “Please place your 
document.” You are now ready to read. 

Note: Keep the platform clear of any documents until you hear “Please 
place your document.” 

How to Read with Eye-Pal SOLO LV  

To start reading, place a document onto the Eye-Pal SOLO LV base. Place 
it in any direction, as the orientation does not matter. You will hear a 
“shutter” sound.  

Eye-Pal SOLO LV will begin to read your text aloud in a few seconds. With 
your monitor or TV connected, you will see the text on the screen. 

To magnify the text on the screen, press the Zoom button on the keypad 
which is the white square, located on the upper left corner, marked with a 
raised black plus sign. Because Eye-Pal SOLO LV “wraps words”, the words 
will never run off the screen. 

If you remove the document, you will hear, “Please place your document”. 
You may either replace the document or resume reading, by pressing the 
yellow round Pause/Resume button on the front panel of the base or the 
Pause/Resume button on the Keypad. 

Note: Eye-Pal SOLO LV can only read text that is within the borders of 
the base platform. Any text outside of the borders will not be read. Be 
sure not to obstruct the camera’s vision with your hands.