BIOS Setup
F-I90HD
2-13
2.6 Power Management Setup
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
ACPI Suspend Type
S3(Suspend To RAM)
Item Help
- Resume by USB From S3
Enabled
Power Button Function
Instant-Off
Wake Up by PME# of PCI
Disabled
Wake Up by Onboard LAN
Disabled
Wake Up by Wake# of PCIe
Disabled
Wake Up by Alarm
Disabled
X - Date(of Month) Alarm
0
X - Time(hh:mm:ss) Alarm
0 : 0 : 0
Power On Function
Button Only
X - KB Power On Password
Enter
X - Hot Key Power On
Ctrl-F1
Restore On AC Power Loss
Power Off
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
ACPI Suspend Type
This item selects the type of Suspend mode.
-
Resume by USB From S3
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in
the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI
Suspend Type” is set to [S3(STR)].
Power Button Function
This item selects the method of powering off your system:
[Delay 4 Sec.]:
Pushing the power button for more than 4 seconds will power off the system.
This will prevent the system from powering off in case you accidentally hit or pushed the power
button.
[Instant-Off]:
Pressing and then releasing the power button at once will immediately power
off the system.
Wake Up by PME# of PCI
When set to [Enabled], access through the add-on PCI card can remotely wake up the system
that was in Soft-Off condition. The PCI card must support the wake up function.
Wake Up by Onboard LAN
When set to [Enabled], access through the onboard LAN port can remotely wake up the system
that was in Soft-Off condition.
Wake Up by Wake# of PCIe
When set to [Enabled], access through the add-on PCI Express card can remotely wake up the
system that was in Soft-Off condition. The PCI Express card must support the wake up function.
Wake Up by Alarm
When set to [
Enabled
], you can set the date and time you would like the Soft-Off PC to
power-on in the “
Date (of Month) Alarm
” and “
Time (hh:mm:ss) Alarm
” items. However,
if the system is being accessed by incoming calls or the network (Resume On Ring/LAN) prior to
the date and time set in these items, the system will give priority to the incoming calls or
network instead.
Summary of Contents for Fatal1ty F-I90HD
