Installing DIMMs
To install any kind of DIMM module do as follows:
1. Orient the short section of the edge connector so
that it is at the upper end of the socket.
2. Insert the module edge into the socket at a 90° angle
so that the contacts insert as far as they will go.
3. The retaining clamps at each end rotate upward to
secure the module in the socket.
The figure below shows where the orientation features
are located.
DIMM module
orientation short
connector
SIMM module
cut-away corner
goes at this end
Memory Module Orientation
Summary of Contents for PR5
Page 10: ...System Block Diagram ...