JP8: Flash ROM Type
This jumper is set at the factory for the type of Flash ROM
chip installed. You should not change the setting and it is
shown here for reference only. This jumper may be re-
placed by hardwiring directly onboard on some boards.
There are two types of Flash ROM chip, 5-Volt and 12-
Volt. The chip type has no functional effect. The settings
and location are shown below.
JP8: Flash Chip Type
This jumper is factory set for the type
of Flash Memory Chip installed. The
jumper may not be present on some
boards, with the setting hardwired
on the board instead.
Jumper JP8 Location
JP8 Flash Type
Pin 1
JP8: Flash Memory Chip Type
Pins 1-2 Pins 2-3
5-Volt Chip
Short
12-Volt Chip
Short
Note:
Jumper may not be present and may be hardwired instead
x
x
x
Summary of Contents for PR5
Page 10: ...System Block Diagram ...