Hardware Setup
2-3
2.3. Installing the CPU
This server board provides dual 604-pin
Zero Insertion Force (ZIF) sockets to
install the Intel Xeon CPU.
NOTE:
This server board also supports
the Xeon CPU of 603-pin package.
NOTE:
This server board supports installing either one or two CPUs. To set up
system with only one CPU, you MUST install it in the Primary Processor Socket
(Socket CPU0 in this model). To install a second processor, you must verify that the
second processor is identical to the first processor of same voltage and speed. Using
non-identical processors could cause system failure.
2.3.1.
Installing Retention Modules
1. Remove power from your system by unplugging
the AC power cord.
2. Remove the chassis cover (see your system or
chassis documentation for instructions).
3. Locate the CPU sockets.
4. Insert the retention modules and tighten four
retention screws.
User’s Manual
Summary of Contents for SI-2PA
