| Installation –
Mechanical installation of the wallbox on the mounting plate
20
4
Using the Torx screwdriver and the two remaining
5×20 flat-head screws, hand-screw the wallbox into
the two lower fixing points of the mounting plate
(torque: max. 2 Nm).
5
Connect the supply cable to the internal RCCB or
terminal block (basic models) of the eMH1.
6
Using the Torx screwdriver, secure the power supply
cable in the internal strain relief.
NOTE
Completing the installation
To complete the installation of the WHEMH10 mounting plate, go to
Step 13
.
The following working steps are only relevant to the PVEMH10 mounting plate (
Steps 7
to
10
) and the
1W0001 mounting plate (from
Step 11
onwards).
