Installation –
Preparation and fixing to the POLEMH1 mounting pole |
17
Once the POLEMH1 is properly installed and the supply cable properly laid, proceed as follows to fix the mounting
plate to the POLEMH1:
1
Remove the blind plugs from the six thread points
of the mounting pole by carefully pushing them for-
ward with a screwdriver on the inside of the mount-
ing pole.
y
Keep the blind plugs in case you want to operate
the eMH1 Wallbox without the mounting plate
on the POLEMH1 at a later time.
2
Install the mounting plate and align it with the
thread points on the mounting pole.
y
WHEMH10:
Run the supply cable through the
opening.
y
1W0001 and PVEMH10:
Run the supply cable
and the control cable of the mounting plate
through the opening.
3
Screw the mounting plate into the thread points us-
ing the six M5×20 countersunk screws and the Torx
screwdriver.
4
Close the installation openings with the six blind
plugs.
After fixing the mounting plate to the POLEMH1, you can proceed with the preparation of the eMH1 Wallbox.