| Introduction to the WHEMH10, 1W0001 and PVEMH10 mounting plates –
Compatible products
10
WARNING!
Retaining the lock number
If you lose one or both keys, you can order more via ABL’s Customer Service, as long as you
have noted down the lock number. Without a lock number, the entire switching element of the
1W0001 must be replaced.
Be sure to make a note of the lock number of both keys supplied with the 1W0001!
The lock number is the three right-hand digits directly below the key head.
031 XXX
The PVEMH10 mounting plate additionally contains:
8 – 230V AC/DC coupling relay for
connecting to the inverter of a PV
system, 1 pc
Top-hat rail 12 V power supply unit
for powering an inverter with float-
ing output, 1 pc
NOTE
Checking the components included
Check immediately after unpacking whether all components are included: should any components be missing,
please contact the dealer from whom you purchased the mounting plate.
Compatible products
No separate accessories are offered for the WHEMH10, 1W0001 and PVEMH10 mounting plates.
However, the following products are compatible with the mounting plates:
POLEMH1
Mounting pole for installing the eMH1 Wallbox with or without mounting
plates
h = 1,647 mm, w = 285 mm, d = 180 mm
Wallbox eMH1
Charging station from ABL for charging an EV, available either as a version with
a permanently integrated charging cable or with a charging socket
h = 273 mm, w = 222 mm, d = 116 mm
(Housing without protrusions)
You can find further information on
ABL
charging stations and accessories at
.
