| Installation –
Preparing the eMH1 Wallbox for installation
18
Preparing the eMH1 Wallbox for installation
Before screwing the eMH1 Wallbox to the mounting plate, you must first prepare it.
Steps
1
to
5
are identical for all mounting plates. For the 1W0001 and PVEMH10 versions you will also need to per-
form Step
6
.
Proceed as follows:
1
Open the housing cover of the Wallbox eMH1 using
the key supplied and flip it up.
2
Loosen the four screws of the upper part of the
housing using the Phillips head screwdriver.
y
Keep the four screws in a safe place.
3
Remove the upper part of the housing from the
housing base.
4
Using the Torx screwdriver (T20), loosen the internal
strain relief, which is located on the inside of the
rear shell of the housing above the large grommet
for the supply cable.