| Using the mounting plates in practice
24
Using the mounting plates in practice
All three mounting plates offer the option to roll up the charging cable of the eMH1 Wallbox using the bracket on the
front and thus store it neatly at the charge point.
The 1W0001 and PVEMH10 mounting plates also allow the charging process to be specifically blocked/enabled
(1W0001) or the enabling of the charging process to be controlled via the inverter of a PV system (PVEMH10) via their
respective switching functions.
The following sections describe these functions in more detail.
Enabling and blocking the charging function with the 1W0001
The 1W0001 mounting plate offers a switch lock on the front of the cable holder which can be used to block and spe-
cifically enable access to the charging function of the installed wallbox for authorised persons. In normal operation,
the key switch should always be switched off and only unlocked for the charging process.
WARNING!
Replacement of keys in the event of loss
The 1W0001 is supplied with two keys for the switch lock. If you lose one or both keys, you can or-
der more via ABL’s Customer Service, as long as you have noted down the lock number. Without a
lock number, the entire switching element of the 1W0001 must be replaced.
Be sure to make a note of the lock number of both keys supplied with the 1W0001! The
lock number is the three right-hand digits directly below the key head.
Proceed as follows to authorise the charging procedure:
1
Connect the vehicle to the wallbox.
2
Turn the key to the
I
position in order to authorise
the next charging procedure.
y
The charging procedure starts upon request of the
vehicle.
031 XXX