Using the mounting plates in practice –
Selecting the charging mode for the PVEMH10 |
25
3
When charging is complete, return the key to the
0
position.
y
The charging function is locked – no charging
takes place until the charging function is enabled
again.
NOTE
Interrupting the charging process using the key switch
If you move the key switch to the
0
position during an active charging process, the charging process is interrupt-
ed immediately. Return the key switch to the
I
position in order to authorise the charging procedure.
WARNING!
Cancelling the charging process via the vehicle
You are advised to always cancel the charging process via the vehicle first and then move the key switch to the
0
position. Otherwise, the internal components of the eMH1 Wallbox may wear out.
Selecting the charging mode for the PVEMH10
The PVEMH10 mounting plate has a selector switch on the front of the cable holder which allows you to switch the
supply for the charging process between photovoltaic (
ECO
) and mains (
GRID
) power.
NOTE
Setting up the inverter
All operation settings as well as the setup of a threshold value from which the charging process is enabled via
PV current are made on the inverter.
You will find all the necessary information in the instructions for your inverter.
Proceed as follows to switch the charging mode:
1
Connect the vehicle to the wallbox.