User manual Version 1.0
Modbus Gateway
(2) Configure Slave B: Set the IP address and TCP Port of Slave B, as well as ID range for Slave B.
Enter the Slave B parameters, Salve IP 192.168.100.32, TCP Port 502, using TCP (communication protocol)
as the Data Mode, and the slave device response time. Enter the ID and then click
to add to
the list. Click
after configuring the slave device and ID to add to the list.
Example 3: Modbus Gateway to Modbus Gateway Direct Link
When the Modbus Slave and Modbus Master both uses the serial ports and is able to communicate with
each other through the Ethernet connection, then the Modbus Gateway direct link feature can be used.
Setup procedures:
1.
Set the port on a Modbus Gateway as the slave device shown in Example 1, and enable the
connection to the other device.
2.
Set the port on the other Modus Gateway as the master device shown in Example 2, and point the
slave device as the opposing Modbus Gateway.
For setting of the Master and Slave modes, please refer to procedures in Examples 1
