0010456_A1
ABNOX Temperature Controller AXTR-xxxxxx-xxxxx
Page 58 of 84
6 Technical Data / Installation Information
Section 6.1 below provides installation instructions and dimensions for the mechanical mounting of the ABNOX
Temperature Controllers AXTR-024VDC and AXTR-230VAC, as well as the applying technical data. Please
refer to section 6.2 for the technical data and dimensions of the solid-state relay SSR.
6.1 ABNOX Temperature Controller AXTR
Both types (AXTR-024VDC and AXTR-230VAC) have the same dimensions and identical steps for mounting.
Figure 6 shows the outside dimensions. For mounting on a switchboard, a square cut with 45
+0,6
[mm] side
length is required.
Figure 14:
Dimensions of the AXTR
Figure 7 shows you how to mount. Insert the device from the
front into the opening in the switchboard, and make sure that
the gasket fits properly (1). From the back of the switchboard,
place the fastening frame on the device and push the springs
against the back of the switchboard (2) until the latches click
into the designated grooves and the device is properly fixed.
Figure 15:
Mounting the AXTR
Switchboard cut 45
+0,6
x 45
+0,6
Units [mm]
