14
that it is going to transmit the data. Upon receipt, the Access Point will
respond with a CTS message to all station within its range to notify all other
stations to defer transmission. It will also confirm the requestor station that
the Access Point has reserved it for the time frame of the requested
transmission.
Beacon Interval
: Enter a value between 20-1024 milliseconds. The Beacon
Interval value indicates the frequency interval of the beacon. A beacon is a
packet broadcast by the Router to synchronize the wireless network. The
default value is
100
.
Inactivity Time
: By default, the unit adaptively selects the highest possible
rate for transmission. For most networks the default setting is
30000
that is
the best choice. If obstacles or interference are present, the system will
automatically fall back to a lower rate.
Preamble Type
: A preamble is a signal used in wireless environment to
synchronize the transmitting timing including Synchronization and Start
frame delimiter. If you want to change the Preamble type into
Long
or
Short
, please select the mode you need.
Broadcast SSID
:
•
Enabled
: This wireless Router will broadcast its SSID to stations.
•
Disabled
: This wireless Router will not broadcast its SSID to stations. If
stations want to connect to this wireless Router, this Router’s SSID
should be known in advance to make a connection.
WMM
: Select
Enabled
or
Disabled
to execute WMM function.
Apply Changes
: Click to save and apply the current setting.
Reset
: Click to clear and reset the current settings.
Access
Control
Click
Setup
to enter the
Wireless Access Control
screen.
Wireless Access Control Mode:
Select the Access Control Mode from the
pull-down menu.
•
Disable
: Select to disable Wireless Access Control Mode.
•
Allow Listed
: Only the stations shown in the table can associate
with the Wireless Router.
•
Deny Listed
: Stations shown in the table won’t be able to associate
with the Wireless Router.
MAC Address:
Enter the MAC Address of a station that is allowed to
access this Router.
Comment:
You may enter up to 20 characters as a remark to the previous
MAC Address.
Apply Changes:
Press to save the new settings on the screen.
Reset:
Press to discard the data you have entered since last time you press
Apply Changes.
Current Access Control List:
This table displays you the Router MAC
