Chapter 4: Web Configuration
49
Transmit
Select to enable or disable RIP protocol for transmit.
Receive
Select to enable or disable RIP protocol for receive.
Enable Static
Route
If you connect several routers with this Wireless Router, you may need to
set up a predefined routing rule to have more effective network
topology/traffic, this is called static route between those routers and the
Wireless Router.
To set static routers, enter the settings including route IP address, route
mask, route gateway and the route Interface from LAN or WAN.
IP Address
Set up the IP address that would like to send the packets pass through.
Subnet Mask
Set up the Subnet Mask that would like to send the packets pass through.
Gateway
Set up the gateway that would like to send the packets pass through.
Metric
It is used by a router to make routing decisions.
The metrics used by a router to make routing decisions. It is typically one
of many fields in a routing table. Router metrics can contain any number
of values that help the router determine the best route among multiple
routes to a destination. A router metric typically based on information like
path length, bandwidth, load, hop count, path cost, delay, Maximum
Transmission Unit (MTU), reliability and communications cost.
Interface
Select the interface of the setting path.
Management
Status
This page shows the current Wireless Router settings information.
