EN
7
Operating Instructions
ASSEMBLING YOUR WALKSLIM 610
• First find the right spot for your WalkSlim 610 , ensuring you choose a location that is
flat and open, free of sharp objects, with a sufficient 1 metre clear space around the
treadmill.
• Remove the WalkSlim 610 from its packaging and place on the floor.
• Assemble the handrail, handles and phone holder according to the diagram below.
1. Open side handrail locking clip.
2. Raise handrail to fully expanded vertical position. The treadmill is now in running
mode and the maximum speed of the tread belt is 12Km/Hr.
3. Retract the handrail slightly so the handrail locking clip can shut and lock the
treadmill upright. Test that the handrail is firmly in place.
4. Fix the phone holder to the centre of the handrail with 2 bolts.
5. Take out the 4 rectangular rubber plugs, insert the right and left handles to
corresponding position and lock them in by inserting screws through the holes in
the back.
6. Put the 2 rubber square plugs back into the square holes in the back
7. Put Plug in the top right corner.
• Before you assemble the WalkSlim 610 the tread belt must be lubricated with the
silicone oil provided.
Note: When handrail is folded and parallel to the tread belt, the WalkSlim 610 is in
walking mode and the maximum speed of the tread belt is 4Km/Hr. Remove the left and
right handle and plug the square rubber stopper when using the walking mode.
