EN
13
The tread belt is
slipping
•
Tread belt is too loose or too tight. Adjust the tread belt
tightness to the correct tension. The tread belt should be able
to be lifted from the base by about 5-7.5cm by hand. If you
feel there are occasional pauses as you are walking normally,
it means the belt has become loose. Over time the tread belt
will loosen due to wear or stretching and an adjustment must
be made.
•
Simultaneously rotate the left and right adjustment screws
together clockwise for half a circle.
The Treadmill
will not speed up
slow down
• Please contact our Customer Service Centre.
The Display
Screen does not
work
• Please contact our Customer Service Centre.
The Treadmill is
losing speed
• Add lubricant oil to the underside of the tread belt as per
instructions on page 7 of this manual.
The belt is
running to the left
1. Turn the adjustment screw on the right side 1/4 turn
clockwise using the Allen key provided.
2. Start the WalkSlim 830 to check the new position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the Treadmill
for 1-2 minutes and observe the tread belt to ensure that
is running smoothly. If it’s not centralised, then repeat the
adjustment steps again.
The belt is
running to the
right
1. Turn the adjusting bolt on the left by 1/4 circle clockwise
using the Allen key provided.
2. Start the WalkSlim 830 to check the new position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the Treadmill
for 1-2 minutes and observe the tread belt to ensure that
is running smoothly. If it’s not centralised, then repeat the
adjustment steps again.
