EN
8
HOW TO LUBRICATE THE TREAD BELT
• Lubricating your WalkSlim 830 treadmill is essential before starting to use it for the
first time along with during normal use.
• During normal use, friction marks may appear between the tread belt surface and
the treadmill base. To avoid unnecessary friction and to maximize the life of your
treadmill, it is recommended to lubricate the tread belt surface with lubricant after
every 10-15 times or according to the following schedule:
• Lightweight users (less than 3 hours/week) – Lubricate once every 3 months
• Moderate users (3-6 hours/week) – Lubricate once every 2 months
• Heavyweight users (more than 7 hours/week) – once every month
The following is a step-by-step guide
1. Make sure the treadmill is unplugged and place it on an even, non-slippery surface.
2. Lay the treadmill down so its left side is facing up.
3. Lift the tread belt surface up starting from the upper corner.
4. Apply 1-15ml of Silicone Oil Lubricant by squeezing droplets underneath the tread
belt surface, ensuring the lubricant is applied at least 10-15cm towards the middle
of the tread belt.
5. Lift the treadmill back up, and lay it down so the right side is facing up
6. Lift the tread belt surface and apply the Silicone Oil Lubricant underneath as you did
in steps 3 and 4.
7. Return the treadmill to its operating position.
Remember proper lubrication is an important factor in
maintaining the treadmill. To check if you need to add
lubricant, make sure the treadmill is turned off at the
power outlet. Run your hand under the tread belt from
the top to the bottom. If your hand is slightly damp
with silicone oil there is no need to lubricate. If your
hand is completely dry, it is time to add lubricant
