2
SAFETY WARNING
Dismantling / Modifying equipment
The internal high-voltage circuit module is forbidden
to dismantle if without qualified technician＇s operation.
Never insert anything metallic into cabinet opening of the
device (touch monitor).
Do not modify the internal wiring or install other
electronic products inside the device.
The damage to equipment or personal injury caused by
dismantling/modifying is not liability of the device
manufacturer.
Power input
Make sure the voltage designation of the device
corresponds to the local electrical supply. The touch
monitor is suitable for AC 100-240 V power supply.
Keep the power outlet from being stressed bending.
Disconnect the power plug when cleaning the device.
Do not touch the power plug with wet hands to avoid
electric shock.
For preventing from either electric shock or noise
interference, the ground wire of AC power cable should be
well connected to earth ground. Make sure that the
power-plug is fully inserted into the power outlet.
Environment
1.
Temperature and humidity
Do not expose the device to extreme temperature
conditions or to extreme humidity conditions
(non-operating).
2.
Placement
Do not install the device on a tilted or unstable
surface and make sure that the device is not placed on
the edge of the installation base.
When mounting on a moving stand, ensure that all screws
are properly installed and the device is balanced.
