MC96FM204/FM214
130
April 7, 2016 Ver. 1.8
12.3 IDLE Mode
The power control r
egister is set to ‘01h’ to enter the IDLE Mode. In this mode, the internal oscillation circuits
remain active. Oscillation continues and peripherals are operated normally but CPU stops. It is released by reset
or interrupt. To be released by interrupt, interrupt should be enabled before IDLE mode. If using reset, because
the device becomes initialized state, the registers have reset value.
Figure 12.1 IDLE Mode Release Timing by External Interrupt
External
Interrupt
OSC
Normal Operation
Release
CPU Clock
Stand-by Mode
Normal Operation
Summary of Contents for MC96FM204
Page 17: ...MC96FM204 FM214 April 7 2016 Ver 1 8 17 4 Package Diagram Figure 4 1 20 Pin SOP Package ...
Page 18: ...MC96FM204 FM214 18 April 7 2016 Ver 1 8 Figure 4 2 20 Pin TSSOP Package ...
Page 19: ...MC96FM204 FM214 April 7 2016 Ver 1 8 19 Figure 4 3 16 Pin SOP Package ...
Page 20: ...MC96FM204 FM214 20 April 7 2016 Ver 1 8 Figure 4 4 16 Pin TSSOP Package ...