EN
EN
P. 16 - P
. 17
Fitting the side walls
1. Attach the flaps on one side of the first side wall from top to bottom to a leg. The opening in the canvas goes around the pin
of the leg.
2. Affix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where the side wall has already been
attached to the leg.
3. Attach the flaps on the other side of the side wall from top to bottom.
4. Affix the flaps on one side of the second side wall to the rear of the side wall already fitted.
5. Affix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where the side wall has already been
attached to the previous one.
6. Repeat step 3. Attach all the side walls in the same way.
1.
3.
2.
At each corner of the roof canvas is a ring, to which you can attach a tension strap. Pull this tight.
You can secure the bottom edges of the side walls using tent pegs in the loops provided for this purpose. There are also holes in
the base plates of the legs for this purpose. You can also place weights on the base plates.
Anchoring the tent
