Part number 20079, Rev 0
17
MAINTENANCE AND CLEANING
Manual-Defrost Freezers (All models except ABT-3020AP) should be defrosted whenever ¼ to ½
inch of frost has accumulated. Use the procedures in the defrosting section starting at the
bottom of this page for best results. They should also be cleaned periodically. Use the cleaning
agents and suggestions in the table below for best results.
Model ABT-3020AP is an Auto-Defrost Freezer and requires little maintenance. Like the other
models, it should be cleaned periodically to keep it running efficiently. Use the cleaning agents
and suggestions in this table for best results.
CLEANING
PART
CLEANING AGENTS
TIPS AND PRECAUTIONS
Interior and Door
Liners
Soap and water
Baking soda and water
Use 2 tablespoons of baking soda in 1 quart of
warm water
Be sure to wring excess water out of sponge or
cloth before cleaning around controls, light bulb
or any electrical parts.
Door Gaskets
Soap and water
Wipe gaskets and their seating surfaces with a
clean soft cloth
Shelves
Soap and water
Do not wash removable shelves in dishwasher
Exterior and
Handles
Soap and water
Non Abrasive Glass
Cleaner
Do not use commercial household cleaners,
ammonia, or alcohol to clean handles
Use a soft cloth to clean smooth handles
Do not use a dry cloth to clean smooth handles
Manual Defrosting -
All models except ABT-3020AP
It is important to defrost and clean the freezer when ¼ to ½ inch of frost has accumulated. Frost
may tend to accumulate faster on upper part of the freezer due to warm, moist air entering the
freezer when the door is opened. Between defrost evolutions; you can minimize frost build-up
by using a plastic scraper to remove frost. Scrape with a pulling motion. Never use a metal
