background image

Part number 20219, Rev 0 
 

15 

 

PRODUCT WARRANTY INFORMATION 

 

HORIZON SCIENTIFIC, INC. PRODUCT WARRANTY

 

Horizon Scientific, Inc. warrants to the original purchaser every new Horizon Scientific, Inc. refrigerated 
unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, when such 
unit is installed, used, and maintained in accordance with provided instructions, for a period of two (2) 
years.    The  warranty  period  starts  two  weeks  from  the  date  of  shipment  from  Horizon  Scientific,  Inc.  
This  two  week  period  allows  ample  shipping  time  so  that  the  warranty  will  go  into  effect  at 
approximately the same time your equipment is delivered.  Unless subject to prior written agreement 
with

 

Horizon Scientific, Inc., this warranty does not allow for any warranty start deferment greater than 

two  weeks  from  date  of  shipment  due  to  a  delayed  installation  and/or  start-up.    By  purchasing  any 
product from Horizon Scientific, Inc., you and any entity for which you are purchasing acknowledge and 
agree  to  each  and  every  provision  contained  herein,  and  all  other  Notices  and  Terms  provided  to 
Purchaser by Horizon Scientific, Inc., which are hereby incorporated. 

Under this warranty, Horizon Scientific, Inc., through its authorized service organizations, will repair, or 
at  its  option,  replace  any  part  found  to  contain  a  manufacturing  defect  in  material  or  workmanship 
without  charge  to  the  owner  for  parts  and  service  labor.  Replacement  or  repaired  parts  will  be 
warranted  for  only  the  unexpired  portion  of  the  original  warranty.  Horizon  Scientific,  Inc.  will  not 
assume  any  shipping  or  cartage  costs  for  parts  under  warranty.  These  costs  shall  be  paid  by  the 
customer. 

ADDITIONAL THREE YEAR COMPRESSOR WARRANTY 

In addition to the two (2) year warranty stated above, Horizon Scientific, Inc. warrants its hermetically 
and  semi-hermetically  sealed  compressors  to  be  free  from  defects  in  both  material  and  workmanship 
under normal use and service for a period of three (3) additional years from the end of the initial two (2) 
year warranty period, but not to exceed five (5) years after shipment from Horizon Scientific, Inc. 

Compressors  determined  by  Horizon  Scientific,  Inc.  to  have  been  defective  within  this  extended  time 
period  will,  at  Horizon  Scientific,  Inc.

'

s  option,  be  either  repaired  or  replaced  with  a  compressor  or 

compressor parts of similar design and capacity.   

The  three  (3)  year  extended  compressor  warranty  applies  only  to  hermetically  and  semi-hermetically 
sealed parts of the compressor and does not apply to any other parts or components, including, but not 
limited to, cabinet, paint finish, temperature control, refrigerant, metering device, driers, motor starting 
equipment, fan assembly or any other electrical components. 

Horizon Scientific, Inc.’s sole obligation under this warranty is limited to either repair or replacement of 
parts,  subject  to  the  additional  limitations  below.    This  warranty  neither  assumes  nor  authorizes  any 
person to assume obligations other than expressly covered by this warranty. 

NO CONSEQUENTIAL DAMAGES.

  Horizon Scientific, Inc. is not responsible for economic loss; profit loss; 

or  special,  indirect  or  consequential  damages,  including  without  limitation,  losses  or  damages  arising 
from  contents  spoilage  claims  whether  or  not  on  account  of  refrigeration  failure,  electrical  failure, 
power  failure,  or  compressor  failure.    HORIZON  SCIENTIFIC,  INC.’S  MAXIMUM  CUMULATIVE  LIABILITY 
RELATIVE TO ALL CLAIMS AND LIABILITIES, INCLUDING OBLIGATIONS UNDER ANY INDEMNITY, WHETHER 

Summary of Contents for PH-ABT-UCBI-0420

















Reviews: