ENG
8
B. Pre-charge, constant current & constant voltage charging: clamp the output terminal to the battery to identify 6V
or 12V battery; for 6V battery, it will start charging in 6V/slow mode immediately; for 12V battery, it enters 12V/slow
mode by default; you can press the MODE button to switch among the three modes sequentially(Slow/Fast/Low
Temp), each time you press the button, the backlight is turned on for 10 seconds; the display effect is shown in Fig. 9;
Fig. 9
C. Float charge: enter the float charging state, the battery icon shows full, and the real-time voltage and FUL
characters display alternately at 1Hz frequency. In this stage only the backlight will be “ON” when you press the
button; no mode selection is possible during the float charge, as shown in Fig. 10 below:
Fig. 10
D. Power-down memory: in the charging process, unplug the power plug or in case of power outage, the product will
save the original charging mode as long as the battery voltage exceeds 5V; the LCD screen doesn’t have display but
the “power” LED (Green) will be “ON, the maximum memory time is 12 hours; when the power resumes, it will
continue to charge in the original state;
E. Charging completes: unplug the power plug, and then remove the clips from the battery.
-MSA International- 5, rue bommel ZAE Robert Steichen L-4970 Hautcharage LUXEMBURG
Display
alternately
at 1Hz
