Absaar HF-1202, Directions For Use Manual

10

FEATURES

1.

 Charging indicator - yellow LED, when battery is charging the yellow LED is lit.

2.

 Full charge indicator - green LED, when the battery is fully charged or the charger switches into float charge 

mode, the LED is lit; and when there is no load in the circuit, it also illuminates.

3.

 Reverse polarity indicator - red LED, when battery clips are wrongly connected to the battery the LED is lit

4.

 DC cable - DC output cable with red (+) and black (-) clamps for connection to the battery.

5.

 Ventilation openings - be sure the ventilation openings are free from obstruction.

6.

Power cable - connect to a standard 230V AC power outlet.

Note: 

the 2A battery charger is the correct charger for battery capacities up to 30Ah, it is also a good mainte-

nance charger for batteries with a capacity of up to 30Ah.

OPERATION INSTRUCTIONS

· Ensure the battery charger is disconnected from the power supply.

· Connect the red charger clamp to the positive terminal of the battery (+) symbol.

· Connect the black charger clamp to the negative terminal of the battery (-) symbol.

· Plug the charger into the AC mains power. The yellow LED will light up showing that the 

battery is charging.

CAUTION: If the yellow charging light turns off and the red light turns on, immediately 

disconnect from the AC mains power, check the polarity of the battery clips to the battery 

terminals.

· When fully charged, the green LED light turns on. The recharge time will vary based on 

the capacity and discharge state of the battery.

· Disconnect the power supply cable from the standard AC outlet.

· Disconnect the black charge clamp from the negative terminal of the battery (-) symbol. 

· Disconnect the red charge clamp from the positive terminal of the battery (+) symbol.

· Store the battery charger in a dry place.