Absco Industries
Assembly Instruction Manual
ABSCO SKILLION CARPORT
MODEL: CPDN2
5.50mW x 5.50mD x 2.37mH
Model: CPSN2
25/11/22
13
BRACING
SHEETING
Attach the roof braces to the underside of the
beams.
• Use the six ZACO120 between the cross beams.
• Use the four shorter ZACO120
A
braces from the
cross beams to the end beams.
It is
critical
that you begin at the
rear of the structure.
Align the short edge of the sheets
with the edge of the rear beam, as
shown in the detail view, and fasten
with a screw in every flat pan into
the framing.
Slip a neoprene washer onto the
tek before screwing for a water
tight connection.
The long edges of the sheeting
should be hard up against the
inside of the side edge beams.
secure along edges at 150mm
centres after both rows of sheet
have been fixed.
Lay four sheets left-to-right with an
overlap of one rib.
The 5th sheet will need to overlap 3
pans (477mm).
The remaining sheets are again
overlapped by 1 rib.
Where the rear row of sheeting
Overlap roof sheets
and fasten with rivets.
Screw
every pan
Screw
every pan
Screws
every 2nd pan
Screws
every 2nd pan
Rivets
every 2nd pan
ZACO120
A
ZACO120
A
ZACO120
1785
=
=
overlaps the front row and a cross
beam fasten with a tek screw in
every second sheet pan.
Make sure the front edge of the
sheeting is hard up against the
inside front of the beam.
NOTE: Overlap the two
centre sheets by three
full pans. This will result
in the coverage being
5500mm
