Absco Industries
Assembly Instruction Manual
ABSCO RURAL SHED
MODEL: 3030RS-PTX
9’ 9 5/16” W x 9’ 9 5/16” D x 8’ 7/16” H
Model: 3030RS-PTX
19/07/2019
1.10
13
Anchoring
FRONT
1 9/16”
13’ 8 15/16”
9’ 8 1/8”
9’ 1 13/16”
9’ 9 1/8”
1427
1427
4’ 6 1/8”
3 1/8”
NOTE:
• For installation next to buildings, fences or other obstacles, the side walls or rear wall may best be
cladded before anchoring.
• Guttering also may be best fitted prior to anchoring.
Recommended slab dimensions - 2950mm Wide x 2975mm Deep
For footing sizes in lieu of a slab refer to engineering drawings.
anchoring holes with a 13/32” masonry bit to a
depth of at least 2 3/16”. Insert the dynabolts into
the holes with the nuts attached and threaded to
be flush with the top of the bolt.
Use a mallet to drive the anchors down far
enough for the nuts to be able to tighten onto
the foundation. Remove the nuts and shift the
frame over the bolts and replace and tighten
down.
Move the entire assembly to the location where
the structure will be anchored. Mark off the stud
locations shown and the move the frame into
position to check alignment.
Adjust markings for small misalignments if less
than 3/8” out. If larger than this, check the frame
for misalignment.
Once aligned mark off the position of the anchor
hole in the brackets, shift the frame and drill out
Wall stud with
MPB (BKT17) for
anchoring
3 1/8”
3 1/8”
3 1/8”
4’ 6 1/8”
1 9/16”
1 9/16”
1 9/16”
