Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO63
6.12m W x 3.11m D x 2.60m H
Model: ADGAZEBO63
4/12/23
1.00
11
0.
Remove protective plastic coating from
guttering components.
1.
Next join both lengths of gutter
RWG24
, to
match the overall finished length of the structure.
Notch out the rolled edges (shown in grey) to
allow one to slide inside the other.
Consider which way you want the water to fall
before notching. Make sure the ‘uphill’ gutter is
notched and inside the other.
2.
Put silicone in the joint and then use two rivets
FAST102
per side.
3.
Take a gutter end stop
RWG25
and test fit it
over an end of the gutter. Mark off the following.
A.
Midpoint along the top
B.
Face of gutter shown
4.
Trim away area shown in grey with tinsnips
5.
Repeat steps at the other end to make the
other end stop.
6.
Attach end caps with a rivet
FAST102
through
the front back and bottom. Joints may be sealed
using silicone.
7.
Test fit the assembly
• Front and rear flashings go inside end caps.
• Roof panel ‘top skin’ sits under top face of
end caps.
• This face will be against the low side beam.
GUTTERING
A
B
4
3
1
5
2
