Absco Industries
Assembly Instruction Manual
ABSCO BUSH RANGER SHED
MODEL: 3023BRK
3.00mW x 2.26mD x 2.30mH
Model: 3023BRK
09/10/2018
1.1
36
ROLLER SHUTTER ASSEMBLY SUPPORT PHOTOS
5
4
4
Position the roller door inside the shed as shown.
You will need to bring it through the opening at
an angle to get it to fi t. Lay on ground as shown if
there is enough fl oorspace. Remove all protective
fi lms at this point.
5
Stand the unit up and position the roller unit
centred in the opening, you can check it is centred
by looking at the guides. They should be running
parallel to the front frame inset the same distance
on both sides.
6
Next drive the Tek screw that is already in the
roller unit through the rest of the way into the front
frame on both sides.
7
Now the roller door is held in place slide the roller
down and fasten at each cross member in the
front frame. This will result in 4 screws per side.
pre-drilling with a 3mm drill bit will make it easier
to drive the 45mm tek screw into the front frame.
6
7
