Electric cars:
Before you go driving an electric vehicle for the first time, you should retract the
electric motor.
Proceed as follows:
1.
Drive the first 2 batteries only with half throttle.
2.
Then you can go on as usual normal.
Nitro fuel cars:
Before you go ride a Nitro car for the first time, set the failsafe in the receiver.
Proceed as follows:
1.
Switch on the transmitter.
2.
Enter current to the receiver, the red LED on the receiver should light up solid
red.
3.
Press on the remote control, the brake function.
4.
Press the "Setting" button on the receiver (see figure). The LED flashes for about
3 seconds. When the flashing stops, the process is completed successfully.
Run-in nitro engine:
FUEL:
Please never use fuel from the gas station! Only use specially model fuel (nitro-
methane).
The fuel has a major impact on the performance of your engine. If you want to use a
other nitro-methane fuel, you have to adjust the
settings of the engine. Is the nitro content higher, the engine produces more power.
But never exceed 25% nitromethane content.
RUN-IN:
The correct run-in is a important point, so you get maximum performance and life. Take
time and don´t rush.
Use the same fuel as you intend to use in subsequent operation.
1.
Fill the fuel in the tank. Close the exhaust and pull the pull starter till fuel is coming
up to the carburetor. Start the engine andset the main needle high-fat. It must
coming a lot of smoke from the exhaust. This has the advantage that the engine is
lubricated by thebold attitude very well from the inside.
