EN/US/CA/A.mist A.mistT/UM-2239-1
5
Subject to alteration without prior notice.
min 45°!
5.3 Transporting A•mist
60
The filter unit is delivered in parts on a wooden pallet and wrapped in plastic foil. The upper
part is placed on top of the bottom part, the filter towers stand one by one.
To prevent damage,
allow the packaging to remain on the sections until it is time to install them.
Secure the filter
unit thoroughly when moving it, or move it lying down. For lifting, uns one of the following
methods:
Fig. 4: Lifting the filter part
and the wooden pallet with a
crane.
Fig. 5:
Lifting the filter part
and the wooden pallet with a
forklift.
TRANSPORT AT SITE / MOUNTING / INSTALLATION
5
5.1 General
When unpackaging the filter unit please check that it has not been damaged during transport.
If a claim is necessary, contact the shipper.
5.2 Transporting A•mist
6C
,
A•mist
10
, A•mist
20
The filter unit is delivered on a wooden pallet and is wrapped in plastic foil.
A•mist
10
and
A•mist
20
have a high centre of gravity, so there is risk for tipping over. Secure the filter unit pro
-
perly or transport A•mist
10
and A•mist
20
lying down. To prevent damage, allow the packaging to
remain on the sections until it is time to install them.
Because the construction of the filter units differ, there are different lifting instructions:
A•mist
6C
: Lift on truck forks or use lifting straps with spacers around the unit.
A•mist
10
and A•mist
20
: Screw lifting eyes (accessory) into the holes at the top of the filter
unit. See fig. 3.
For lifting, use one of the following methods:
Fig.1: Lifting the filter unit on
a wooden pallet with a forklift
truck.
Fig.3: Lifting a vertical filter unit
by using the lifting eyes.
Fig.2: Lifting a vertical filter unit
without pallet. Take filter stage 2
out and lift with the forks under
the crossbeam.
