115
Premere aprire / bloccare
Consigli per l‘eliminazione guasti
Errore / Informazione
Causa
Soluzione
Dopo la procedura di codifica,
alla prima chiusura i LED lam-
peggiano e viene emesso un
segnale acustico prolungato
La porta non è stata chiusa
nella seconda parte della
procedura di codifica
- Ripetere la procedura di
codifica >> 5.3, chiudendo
la porta quando previsto
Durante il normale funziona-
mento i LED lampeggiano (5.6)
e viene emesso un segnale
acustico prolungato
- La porta non è stata chiusa
durante il funzionamento e
l‘attuatore muove il bloccante
della porta contro lo spigolo
della porta
- Una o più batterie sono state
inserite in modo sbagliato
- Il meccanismo della serratura
ha un gioco eccessivo o la por-
ta è stata posizionata male
- Chiudere la porta e ripe-
tere la manovra
- Aprire il vano batterie e
verificare la polarità delle
batterie / Inserire le batte-
rie correttamente >> 6.1b
- Posizionare correttamen-
te la porta
Oliare il meccanismo della
serratura
Prima di ogni rotazione
dell‘attuatore viene emesso un
segnale acustico
Le batterie sono scariche
Sostituire le batterie >> 6.
Prima dell‘apertura della porta
viene eseguita una corsa di
riferimento dell‘attuatore
La porta è stata aperta/chiusa
manualmente con la chiave o è
stata girata la rotella manuale
dell‘attuatore
La corsa di riferimento è
necessaria per il corretto
riconoscimento della
posizione a seguito di una
rotazione manuale dell‘
attuatore mediante chiave
dall‘esterno o rotella ma-
nuale dall‘interno.
2 x
PS 88
AA
+
AA
+
6.1 a
6.1 c
-
ABUS
6.1 e
6.2
6.3
6.1 d
7.
CFA3010 Z-Wave6.indd 115
09.01.2019 16:21:33