Installation and start-up
13
Installation and start-up
Take the following steps in the specified order to install the detector on the
ceiling:
1.
Loosen the smoke alarm device from
the housing base by turning it
anticlockwise.
2.
Break off the safety pin located in
the mounting base.
3.
Mark drill holes through the housing
base.
4.
Drill the necessary holes and attach
the screw anchors, then screw on
the detector base.
When marking out the drill holes, make sure there are no
electrical wires or cables, pipes or other important components
behind them.
Summary of Contents for GRWM30500Q
Page 23: ...Pflege und Wartung 23...
Page 89: ...Locatie kiezen 8...
Page 103: ...Reiniging en onderhoud 22...
Page 117: ...Scelta del luogo di montaggio 8...