21
English
5. Mounting/installation
5.1. Mounting the camera
IMPORTANT!
The camera must be disconnected from the power supply during installation.
Use screw anchors and screws that are appropriate to the surface to fix the camera in place. Drill
appropriately sized holes for the screw anchors used. An opening is provided on the base plate of
the camera mount for cabling at the side.
5.2. Orientation of the camera
Carefully loosen the three fixing screws (see images (1), (2), (3)). Then orient the camera as
required.
(1) Panning
360°
(2) Tilting
90°
(3) Rotation
360°
Do not forget to tighten up the fixing screws again.
The internal cable routing will also be rotated when the fixing screw (3) is rotated. The
camera should therefore not be rotated repeatedly in the same direction otherwise
the internal cables may be damaged.
1
2
3
