ABUS TECHNOLOGIES INC.
2
PT
WARNING
v
This manual should be passed on to the end user.
v
The contents of this manual are subject to change without prior notice.
v
All rights reserved.
v
ABUS gives no warranty of any kind with regard to this manual, including, but not limited to, fitness for a
particular purpose.
v
If any question arises or errors are found, or if any information is missing from this manual, please inform
your supplier or inform at
info@abustek.com
.
v
The specifications mentioned in this manual are limited to those for the standard type under the specified
model number break-down and do not necessarily apply for customized instruments.
v
Please note that changes in the specifications, construction, or component parts of the instrument may
not immediately be reflected in this manual at the time of change.
v
If the customer or any third party is harmed by the use of this product, ABUS assumes no responsibility
for any such harm owing to any defects in the product which were not predictable, or for any indirect
damages.
Although Warning hazards are related to personal injury, and Caution hazards are associated with
equipment or property damage, it must be understood that operation of damaged equipment could, under
certain operational conditions, result in degraded process system performance leading to personal injury or
death. Therefore, comply fully with all Warning and Caution notices.
Information in this manual is intended only to assist our customers in the efficient operation of our
equipment. Use of this manual for any other purpose is specifically prohibited and its contents are not to be
reproduced in full or part without prior approval of Technical Communications Department, ABUS
Technologies
HEALTH AND SAFETY
To ensure that our products are safe and without risk to health, the following points must be noted:
1. The relevant sections of these instructions must be read carefully before proceeding.
2. Warning labels on containers and packages must be observed.
3. Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel
and in accordance with the information given. Any deviation from these instructions will transfer the
complete liability to the user.
4. Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating
in conditions of high pressure and/or temperature.
5. Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry.
Normal safe handling procedures must be used.
6. When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard data
sheets (where applicable) may be obtained from the Company address on the back cover, together with
servicing and spares information.
