8
UK
6.2 Internal
activation
If you want to monitor only part of your object – e.g., only
the contacts of your windows or the ground floor – you
can activate the alarm system internally.
In the alarm centre’s program mode, you can define zones
not to be monitored by internal activation. To activate
internal mode B, C or D:
Enter a valid user code:
1 2 3 4
and then press:
,
or
. Depending on programming, the different zones
are now activated.
The alarm centre has now started the exit delay time so
that you can leave the area. The delay time is now
counted down in seconds. A constant signal tone is
generated for the duration of the delay time.
The remaining sequence of events is as for activating the
complete alarm system.
IMPORTANT:
Immediate activation of internal areas can
also be programmed – i.e., without a delay
time. In that case, there is no constant tone
and the system acknowledges successful
activation of the area.
6.3 Key
switch
With a key switch, you can activate or deactivate your
alarm system with a key instead of a user code. It is also
possible to activate via the control unit and deactivate
using a key switch, or vice versa.
The alarm system can also be activated in different areas
with a key switch, depending on how the zone is
programmed. Also, only the area programmed for a key
switch can be deactivated. An alarm can be stopped
immediately at any time.
TIP:
The use of key switches is particularly useful in the
commercial area. In particular, where there are many
different users, or the risk of passing on the user code to
unauthorised persons is to be avoided.
Summary of Contents for Terxon MX
Page 4: ...4 D 10 5 Zonen sperren 20 11 Systemplan 21...
Page 22: ...22 D...
