11
UK
IMPORTANT:
Some zone types cannot be blocked. You
can only block zones released during the
programming of the zone property. Zones
that cannot be blocked are displayed with
an “X” after the zone number. The control
unit shows:
To activate the alarm system with blocked zones:
Enter your user code and activate an area. The system
emits an error tone and the display shows (example):
To activate the alarm system with the blocked zone, press
the following key:
.
If you have blocked more than one zone, press the key
again until you have confirmed all zones. If you do not
want to activate the alarm system, press the following key:
.
After you have activated the last zone, the alarm system
starts the delay time.
IMPORTANT:
Blocked zones are blocked for one
activation period only.
9.2 User
code
The first user code is also the master code. With this
code, you can create further user codes and user names.
The alarm system can store up to 16 user codes. All users
should have their own codes.
Every time a user is entered, this event is stored in the
event memory with the user number B001, B002,….
The factory-set codes for users 002 to 016 are x002 to
x016.
Apart from the user codes, there is also a panic code
(B017). If the panic code is entered instead of the user
code to deactivate the alarm system, the alarm system is
deactivated, but another exit is activated that can be
silently transmitted by telephone.
User codes B002 to B016 plus the panic code B017 do
not function until they are changed.
To change the user code:
Enter the master code.
The control unit shows:
Press:
4
The control unit shows:
Enter the user code you want to change. If the user codes
have not been changed, enter for users B002 to B016 and
for the panic code B017 the codes x002 to x016 and x017
respectively.
Summary of Contents for Terxon MX
Page 4: ...4 D 10 5 Zonen sperren 20 11 Systemplan 21...
Page 22: ...22 D...
