English
Safety information
1.
Power supply: Power supply unit 100–240 V AC, 50/60 Hz
/
5 V DC, 1 A (included in the scope of
delivery)
Only operate this device through a power source which supplies the mains power specified on the
type plate. If you are unsure of the installation location's power supply, contact your power supply
company. Disconnect the device from the power supply before carrying out maintenance or
installation work.
2.
Overloading
Avoid overloading electrical sockets, extension cables, and adapters, as this can result in fires or
electric shocks.
3.
Cleaning
Only use a damp cloth to clean the device. Do not use corrosive cleaning materials.
Disconnect the device from the power supply before cleaning.
Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1.
Observe the following information to avoid damage to the power cable and plug:
•
Do not modify or manipulate the power cable or plug.
•
Do not bend or twist the power cable.
•
Do not pull the cable when disconnecting the device from the power – always take hold of
the plug.
•
Ensure that the power cable is positioned as far away as possible from any heating
equipment, as this could otherwise melt the plastic coating.
2.
Follow these instructions. Non-compliance with these instructions could lead to an electric shock:
•
Never open the housing or power supply unit.
•
Do not insert any metallic or flammable objects into the device.
•
Use surge protection to prevent damage caused by overvoltage (e.g. in electrical storms).
3.
Disconnect defective devices from the power immediately and contact your specialist dealer.
When installing the device in an existing video surveillance system, ensure that all devices
have been disconnected from the mains power circuit and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation and connection of the
device. Improper or unprofessional work on the power supply system or domestic installation
puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or become connected
as a result of a malfunction.
Unpacking the device
Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, you must start by inspecting the device. If the
device shows signs of damage, return it in the original packaging and inform the delivery
service.
76
