3. Connect power cord to a power outlet.
2. Use Category 5 cable (CAT5)
to connect the camera to
Please use CAT5 cross link cable when
the Network Camera is directly
connected to PC.
from Ethernet port to hub/switch.
4.
Install your Camera in Ethernet network
1. Connect your Network Camera to the Ethernet network
5.
Connect to the camera
1. Please note the serial number on the product label.
The serial number is not the same as the
MAC address of the camera.
Example MAC:
0002D1000019 = 00-02-D1-00-00-19
2. Assign IP address
a) Run the „Installation Wizard 2“ from the included software CD.
b) The software will search for installed Eyseo IP devices
on the same Local area network.
3. After searching the main installer window will pop up.
Click on the MAC that matches the one you just noted from the product label
of your device to connect the Internet Explorer to the camera.
4.The standard IP address of
the camera is:
169.254.0.99.
15
16
P O W E R
C O L L I S I O N
L I N K
R E C E I V E
P A R T I T IO N
1
2
3
4
5
www.abus-sc.com
ABUS Security-Center
12VDC / max. 1.5A
MAC: xxxxxxxxxxxx
S/N: xxxxxxxxxxxx
TVIP41550
