43
Safety information
1.
Power supply: Power supply unit – 100–240 VAC, 50/60 Hz
/
12 VDC, 1 A (included in delivery)
Only operate this device through a power source which supplies the mains power specified on the type
plate. If you are unsure of the power supply at the installation location, contact your power supply
company. Disconnect the device from the mains power supply before carrying out maintenance or
installation work.
2. Overloading
Avoid overloading of mains sockets, extension cables and adapters as this can result in fires or
electric shocks.
3. Cleaning
Only use a damp cloth to clean the device. Do not use corrosive cleaning materials.
Disconnect the device from the mains power supply while doing this.
Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1.
Observe the following information to avoid damage to the mains cable and plug:
Do not modify or manipulate the mains cable or plug.
Do not bend or twist the mains cable.
Do not pull the cable when disconnecting the device from the mains power – always take hold of
the plug.
Ensure that the mains cable is positioned as far away as possible from any heating equipment,
as this could otherwise melt the plastic coating.
2.
Follow these instructions at all times. Non-compliance to the instructions could cause an electric shock:
Do not insert any metallic or flammable objects into the device.
Use overvoltage protection to prevent damage caused by overvoltage (e.g. electrical storms).
3.
Disconnect defective devices from the mains power immediately and contact your specialist dealer.
When installing the device in an existing video surveillance system, ensure that all devices are
disconnected from the mains power supply and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation and connection of the
device. Improper or unprofessional work on the mains power supply or domestic installation
puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or become connected
as a result of a malfunction.
Unpacking the device
Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, inspect the device. If the device shows signs of
damage, then return it in the original packaging and contact the delivery service.
Summary of Contents for TVIP62500
