Mini FunFly Flight Controller “Naze32” (
なぜ)
Firmware Upgrade / MultiWiiConf
MultiWiiConf usage is standard, and all the basics are covered at MultiWii website,
http://www.multiwii.com/software
. There are no special requirements for this board, and
default settings are sufficient for stable flight.
To update firmware,
1. Download Flash Loader Demonstrator and latest baseflight firmware from
http://code.google.com/p/afrodevices/downloads/list
2. Plug in USB or apply power.
3. Send ‘R’ (no enter/line feed needed) over serial port at 115200, 8n1.
4. Run Flash Loader, choose USB port, click next until asked for firmware hex file.
5. Upload.
6. When finished, unplug/replug USB or reconnect power.
If flash fails or sending ‘R’ does not enter bootloader mode, extended method is used:
1. Temporarily short bootloader pads (5) on the bottom of the board.
2. Plug in USB or apply power.
3. Follow instruction steps 4-6 above.
