21
Step 2: Insert fi xed long frame support into the long adjuster mid-section end
closer to the adjustment handle. Align the thru holes on each end and insert
a T-handle pin to attach both.
Fixed Long Frame Insert
T1H2 Long Adjuster Mid-section
T-Handle Pin
Step 3: Align the center numbered tube #1 thru hole and one end of the cen-
ter tube shown and insert the T-handle pin (Part #95545) far enough until
the handle cannot slide out freely. Remove the T-Handle Pin on the side with
the adjustment handle and leave out until the tug’s width has been adjusted
to the previously measured width. This connection does not adjust and will
remain intact when adjusting the width of the T1H2 tug. Facing down on the
adjusment handle turn it counter-clockwise until it can no longer turn.
#1 Thru Hole
Figure 1
Adjust to number on front
T1H2 Short Adjuster Mid-Section
Figure 2
Figure 3
*Length will vary
*Length will vary depending on the T1H2 short adjuster*