19
AUTO MODE (HIGH TEMPERATURE TRIGGER)
Pressing the up or down button sets the high
temperature trigger. Your device will be turned
on if the probe’s reading meets or exceeds this
threshold.
If the probe’s reading falls below this trigger point,
your device will be turned off. This turn-off point
can be adjusted using the buffer setting as shown
on page 26.
You may also set this trigger below the low
temperature trigger to create a specific range, in
which your device will only be on when it’s within
this range.
AUTO MODE (LOW TEMPERATURE TRIGGER)
Pressing the up or down button sets the low
temperature trigger. Your device will be turned on
if the probe’s reading meets or falls below this
threshold.
If the probe’s reading rises above this trigger point,
your device will be turned off. This turn-off point
can be adjusted using the buffer setting as shown
on page 26.
You may also set this trigger above the high
temperature trigger to create a specific range, in
which your device will only be on when it’s within
this range.
Note that this trigger can activate as long
as you are in AUTO Mode, even if you are
viewing a different trigger within AUTO Mode.
PM
Note that this trigger can activate as long
as you are in AUTO Mode, even if you are
viewing a different trigger within AUTO Mode.
PM
PROGRAMMING
Summary of Contents for SUNCORE
Page 1: ...SUNCORE SEEDLING HEATING MAT USER MANUAL...
Page 2: ......
Page 32: ...www acinfinity com...
