Dip Switch Settings (Fill in):
Thermostat brand/model* (Fill in) :
Once the thermostat is determined, set it up as a heat pump, and set the reversing valve to energize in heat using the B setting terminal, and tell the thermostat the
reversing valve is energized in heat.
Start up guidelines
Once all of the above has been confirmed turn on the power to both the indoor and outdoor units, and set the system to cooling mode.
Let the system run for approximately 15 minutes.
Check your manifold gauge pressures and compare them to the pressure chart for basic charge verification.
Manifold gauge pressures:
High side pressure
_________________
Low side pressure
_________________
Dry Bulb/Wet Bulb (Fill in):
Outside Air Dry Bulb (Fill in):
Amp/Current Draw (Fill in):
For Tech Support Assistance please have this checklist completed first then call 855-972-2776
Dip Switch Settings (Fill in):
Thermostat brand/model* (Fill in) :
Once the thermostat is determined, set it up as a heat pump, and set the reversing valve to energize in heat using the B setting terminal, and tell the thermostat the
reversing valve is energized in heat.
Start up guidelines
Once all of the above has been confirmed turn on the power to both the indoor and outdoor units, and set the system to cooling mode.
Let the system run for approximately 15 minutes.
Check your manifold gauge pressures and compare them to the pressure chart for basic charge verification.
Manifold gauge pressures:
High side pressure
_________________
Low side pressure
_________________
Dry Bulb/Wet Bulb (Fill in):
Outside Air Dry Bulb (Fill in):
Amp/Current Draw (Fill in):
___________________________________
_
_________
_________________________________
_
________________________________
_
______________________________________________
ForTech Support Assistance please have this checklist completed first then call 855-972-2776
Summary of Contents for AUD24AH2/A1-D
Page 4: ......