SM01P
24
13
PROGRAMMING THE SCL/SCM DRIVE
The drive may be programmed by one of two methods: using the three buttons and 3-digit
LED display on the front of the drive, or by programming the Electronic Programming
Module (EPM) using the optional EPM Programmer . This section describes programming
the drive using the buttons and display, which are shown below:
BUTTONS
DISPLAY
Mode
To enter the PROGRAM mode to access the parameters, press the
Mode
button . This will
activate the PASSWORD prompt (if the password has not been disabled) . The display will
read “00” and the upper right-hand decimal point will be blinking, as shown below:
Press
Mode
Upper right decimal point blinks
Display reads "00"
Use the
and
buttons to scroll to the password value (the factory default password
is “225”) and press the Mode button . Once the correct password value is entered, the
display will read "P01", which indicates that the PROGRAM mode has been accessed at
the beginning of the parameter menu (P01 is the first parameter) . This is shown below:
Press
Mode
to enter password
Use
and
to scroll to the
password value
Parameter menu is accessed
at the first parameter
NOTE
If the display flashes “Er”, the password was incorrect, and the process to enter the
password must be repeated .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
