SM01P
26
If, however, Parameter 16 - UNITS EDITING is set to TENTHS OF UNITS (01), parameter
values and the keypad speed command can be adjusted in tenths of unit increments up
to a value of 1000 (above 1000, whole unit increments only) . Each push of the
or
button will adjust the value by one tenth of a unit . If the
or
button is pressed and
held, the value will increment by tenths of units until the next whole unit is reached, and
then the value will increment by whole units .
When a value above 100 is being adjusted by tenths of units, the value is shifted to the
left by one digit so that the tenths portion of the value can be displayed . This results in
the first digit (reading from left to right) of the value disappearing from the display . Also,
the lower decimal point will blink to indicate that the actual value is above 100 . Once
the value is no longer being adjusted, the value will shift back to the right and the tenths
portion of the value will disappear .
In the example below, Parameter 19 - ACCELERATION TIME is presently set to 243 .0
seconds, and is being increased to 243 .7 seconds .
Go to Parameter 19 and press
Mode
to see present setting ("243"
seconds)
Upper right decimal point blinks
Press
button to see tenths portion
Upper right decimal point and lower
decimal point blink
Value shifts to the left ("2" disappears)
Press
button to scroll up to "43 .7"
Press
Mode
to store new value
13.2 Electronic Programming Module (EPM)
Every SCL/SCM Series drive has an Electronic Programming Module (EPM) installed on
the main control board . The EPM stores the user’s parameter settings and special OEM
default settings (if programmed) . The EPM is removable, allowing it to be installed in
another drive for quick set-up . For example, if a drive is being replaced with a new one,
the EPM can be taken out of the first drive and installed in the new drive . Downtime is
minimized because the new drive does not require programming - it is ready to run when
the EPM is installed .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
