37
SM01P
18 AUTOMATIC SPEED MODE: Closes if an AUTOMATIC (terminal strip) speed
reference is active . Opens if a STANDARD (Parameter 5) speed reference is
active .
19 REVERSE: Closes when reverse rotation is active . Opens when forward rotation is
active (refer to Parameter 17 - ROTATION DIRECTION) .
20 DYNAMIC BRAKING: TB-13E becomes the "trigger" that activates the optional
external Dynamic Braking module . Refer to the instructions included with the Dynamic
Braking option .
21 REMOTE KEYPAD: When the Remote Keypad option is being used, TB-13E must be
set for this function . Also, TB-13B (Parameter 11) must be set for Remote Keypad (13)
and CONTROL (Parameter 14) must be set for REMOTE KEYPAD ONLY (02) .
P14
CONTROL
Parameter P14 selects the source of START/STOP and direction commands .
01 TERMINAL STRIP ONLY: The drive will only respond to START/STOP and direction
commands from the terminal strip .
02 REMOTE KEYPAD ONLY: The drive will only respond to START/STOP and direction
commands from the optional remote keypad . Terminals 13B and 13E must also be
set for the REMOTE KEYPAD option (refer to Parameters 12 and 13) .
P16
UNITS EDITING
P16 allows parameter and keypad speed editing in whole units or tenths of units above
100 . Below 100, the value can always be changed by tenths of units .
01 TENTHS OF UNITS: The value can always be changed by tenths of units (up to a
value of 1000) . If the
or
button is pressed and held, the value will change by
tenths of units until the next whole unit is reached, and then the value will change by
whole units . Refer to Section 13 .1, Setting Values in Tenths of Units Above 100 .
02 WHOLE UNITS: The value can be changed by tenths of units until 99 .9 is reached .
Above 99 .9, the value will change in whole unit increments only . Below a value of
100, if the
or
button is pressed and held, the value will change by tenths of units
until the next whole unit is reached, and then the value will change by whole units .
P17
ROTATION DIRECTION
01 FORWARD ONLY: The drive will only allow rotation in the forward direction . However,
JOG REVERSE (see Parameter 11) will still operate even if FORWARD ONLY is
selected .
02 FORWARD AND REVERSE: The drive will allow rotation in both directions .
P19
ACCELERATION TIME
P19 sets the acceleration rate for all of the speed reference sources (keypad, speed pot,
jog, MOP, and preset speeds) . This setting is the time to accelerate from 0 Hz to the BASE
FREQUENCY (Parameter 27) .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com