26
Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net
Step 2: Installing the Machine Gun
❑
Glue the machine gun onto the cockpit deck using a thin
bead of thick C/A.
☛
The covering material has already been removed from
where the machine gun is installed.
Step 3: Installing the Cockpit Deck
❑
Test fit the plywood cockpit mounting block onto the
wing. The notch in the block fits over the plywood mounting
tabs and the block should face the trailing edge of the wing.
Push the block down firmly.
IMPORTANT
Because of slight differences with wing joining, you may need
to trim the inside edges of the mounting block to fit firmly
over the plywood tabs.
❑
When satisfied with the fit, remove the block. Using a modeling knife, remove the covering material from the wing
where the block glues into place.
❑
Glue the plywood block into place using thick C/A. Allow the C/A to thoroughly cure before proceeding.
❑
Set the cockpit deck onto the wing and align it with the
fuselage.
❑
Use several pieces of masking tape to hold the cockpit
deck firmly in place and aligned.
❑
Using a 1/16" drill bit, drill straight down through the
predrilled hole in the cockpit deck, and drill a pilot hole into
the plywood mounting block.